How to Tap a Maple Tree for Syrup: Learn how to use a "Spile" to tap into your maple tree to harvest syrup from the tree and make your very own delicious home made syrup. 1.  Get a syrup spile, drill, and the correct size of drill bit. 2.  Drill at an upward angle into the tree, deep enough for the spile. 3.  Hammer in the spile and attach the bucket. 4.  Cover the bucket to protect from the elements. 5.  It is best to do this early winter when daytimes are above freezing, and nighttime is freezing. Transcript: Here I am, I’m about to install some maple spiles, which here is one of them right here. I’m going to install this into one of my silver maple trees which is on my property. I’m going to use a drill with a 3/8” bit. You want to take the drill bit, and drill into an angle that is facing upward, and drill into the tree. Put the drill down. There is the hole and we are going to hammer the maple spiles. So most of them have a hook on them at the bottom, to hang the bucket. And aluminum foil to make a makeshift cover, since I don’t have a proper cover for the bucket, to keep the rain, water, and snow from coming into the bucket. I’m going to use a leatherhead hammer to hammer the spile in. Nice and secure. Take the bucket and hang it from there. Put some Reynolds wrap over it (excuse my filming while I do this). Its wrapped around the edges pretty well and has a decent seal. And hopefully we will start getting some maple syrup. From my understanding, the best time to start tapping your maple trees is when the daytimes are warm, above freezing. And the night times are freezing. And that causes some sort of pumping action inside the tree, and allows the sap to flow up and to flow down through the maple spile and into the bucket. In order to make maple syrup from this, you have to boil the maple syrup down for a very long period of time. Its about a 40 to 1 ratio in terms of sugar content. I’ll do some filming of when we actually start boiling over a fire outside.